Hsmworks turning4/1/2024 Stock ID - Sets the Clearance radius in reference to the inside diameter of the Stock, as defined in the Setup.Use the Offset parameter to make adjustments as needed. Model ID - Sets the Clearance radius in reference to the inside diameter of the Model, as defined in the Setup.The Clearance radius must be larger than the Inner radius. Inner radius - Sets the Clearance radius in reference to the Inner radius position.The Clearance radius must be larger than the Outer radius. Outer radius - Sets the Clearance radius in reference to the Outer radius position.Model OD - Sets the Clearance radius in reference to the outside diameter of the defined Model.Stock OD- Sets the Clearance radius in reference to the outside diameter of the defined Stock.Retract - Sets the Clearance radius in reference to the Retract Position.This reference position can be shifted with a positive or negative offset value. The reference can be in relation to the Stock, the Model, a specified Radius, Diameter, or any of the other Radial positions. Shown in Orange, "From" sets the Clearance radius reference position. The tool approaches from and retracts to this position. For ID machining this position is from an inside tube or bore. For OD machining this position is outside the part. Shown in Orange, this controls the radius where the tool rapids to at the start and end of the toolpath.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |